System Connections; Rs-232 Connection - Datalogic lynx Instruction Manual

LYNX™ DATALOGIC

1.3 SYSTEM CONNECTIONS

Connections should always be made with power off.
CAUTION

1.4 RS-232 CONNECTION

The LYNX™ Reader requires the RS232 interface cable and the AC/DC
power adapter to be connected.
To install your reader to your host system, follow these instructions (see
Figure 1.1 below).
1. Insert the cable into the bottom of the handle of the LYNX™ reader.
2. With the host powered down, connect the RS232 interface cable to the
proper port on the host terminal.
3. Connect the power cord to the RS232 interface cable.
4. Connect the AC/DC power adapter at the wall outlet.
5. Turn on the host computer.
Figure 1.1 - RS232 Connection
2