Mitsubishi Electric FR-E700 Installation Manuallines page 14

3) Insert the wire into a socket.
NOTE
 When using a stranded wire without a blade terminal, twist enough to avoid short circuit with a nearby terminals or
wires.
 Place the flathead screwdriver vertical to the open/close button. In case the blade tip slips, it may cause an inverter
damage or injury.
 Wire removal
Pull the wire with pushing the open/close button all the way down firmly with a flathead screwdriver.
Open/close button
When using a single wire or stranded wire without a blade
terminal, push an open/close button all the way down with a
flathead screw driver, and insert the wire.
Flathead screwdriver
Control circuit specifications
Open/close button
NOTE
 During wiring, pulling out the wire forcefully without
pushing the open/close button all the way down may
damage the terminal block.
 Use a small flathead screwdriver (Tip thickness: 0.4mm /
tip width: 2.5mm).
If a flathead screwdriver with a narrow tip is used, terminal
block may be damaged.
Introduced products (as of Jan. 2017)
Product
Flathead
SZF 0- 0,4 x 2,5
screwdriver
 Place the flathead screwdriver vertical to the open/close
button. In case the blade tip slips, it may cause an inverter
damage or injury.
Flathead screwdriver
Type Manufacturer
Phoenix Contact
Co., Ltd.
11