Seat Removal; Seat Belts - Polaris 4X4 700 EFI Owner's Manual

Polaris industries offroad vehicle user manual
Hide thumbs Also See for 4X4 700 EFI:
Table of Contents

Advertisement

Seat Removal

Pull up on the front of the
seat and slide it toward the
front of the vehicle.
Install the seat by sliding
the tabs into the rear of the
seat base. Push down firmly
on the front of the seat until
the pins are fully seated into
the grommets.
Fuel Cap
The fuel tank filler cap is
located on the right-hand side of
the vehicle near the passenger
seat. When refueling, always
use either leaded or unleaded
gasoline with a minimum pump
octane number of 87 R+M/2
octane. Do not use E-85 fuel.

Seat Belts

The RANGER is equipped with lap-style seat belts for the operator and
.
passenger
Falling from a moving vehicle could result in serious injury or death. Always
fasten your seat belt securely before operating or riding in the RANGER.
Passengers under five years of age require special restraints, which are not
available with this vehicle. No person under the age of five may ride in the
RANGER.
To wear the seat belt properly, follow this procedure:
1. Place the belt across your lap as low on your hips as possible. Make
sure that the belt is not twisted.
2. Push the latch plate into the buckle until it clicks.
3. Release the strap, it will self-tighten.
NOTE:
The center belt must be tightened manually by pulling on the strap.
4. To release the seat belt, press the square red button in the buckle's
center.
FEATURES AND CONTROLS
Seat Belt
Gas Cap
WARNING
33

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents