Throttle Cable; Jackshaft Bearing; Driveshaft Bearing - Polaris 340 Edge Touring Owner's Manual

MAINTENANCE
Lubrication

Jackshaft Bearing

✪
Loosen the driven clutch retaining
bolt and pull the clutch outward to
expose the bearing and grease fit-
✪
ting. Inject grease into the grease
fitting in the flangette until grease
purges from inside or outside the
bearing seal (may take only two
pumps). Push the clutch back onto
the shaft and replace the clutch
retaining bolt. Torque to 18 ft. lbs.
(24.4 Nm).

Driveshaft Bearing

✪
Inject grease into the fitting on the
speedometer sensor housing until
grease purges from the seal on the
inside of the tunnel. This should
take approximately two pumps.
Do not use more than four pumps.

Throttle Cable

Lubricate the throttle cable lightly
with grease or oil. With the engine
off, turn the handlebars to the left
and lubricate liberally as shown.
✪
Choke and Choke Cable
✪
Lubricate the choke slide and cables
lightly with oil or grease. Before
turning the engine off, operate the
choke intermittently to draw mois-
ture out of the choke plunger area
and reduce the possibility of the
choke becoming frozen.
91