Check Following Assembly - Korg C1 Owner's Manual

6. Align the bracket holes in the left and right side panels
with the holes in the speaker box, and then secure them
with the four screws (M4) so the gaps on the left and
right sides are equal.
Screws
(M4)
7. Firmly tighten the speaker box screws temporarily tight-
ened in step 4.
Make any vertical and horizontal adjustments necessary
so that the left and right side panels are positioned equally.
8. Ensure that the stand has no gaps and is not tilted, and
that all the screws are tightened firmly.
This completes the assembly of the stand.
9. Place the C1/C1 Air on the stand, make any vertical and
horizontal adjustments, and then fasten them to each
other from the bottom, using two screws (M6)
Position the C1/C1 Air so that it extends about 1 mm from
the rear of the stand.
Screws
(M6)
10. Make sure to attach the anti-tipping brackets be-
hind both side panels. And the anti-tipping bracket
fastened to the left of the code holder at this time.
Attach the anti-tipping brackets, starting with the round
hole at the bottom.
Joints between the side panels and the attached anti-tip-
ping brackets should be even (with no level difference left).
18
Bracket (A)
Dent
Speaker cord
Screws (M4)
Screws
(M6)
Reverse
Screws
Cord
(M4)
holder
Stabilizing felt
If you are concerned about
instability at the installation
location after assembly,
attach the felt to stabilize
the digital piano.
11. Connect the pedal cord and the speaker cord to the con-
nectors on the rear of the C1/C1 Air's connector box.
When connecting the pedal cord and the speaker cord, ob-
serve the correct orientations of the connectors.
The pedal cord or the speaker cord can be detached from
the connector with its locking tab held down.
Locking tab
Speaker cord
12. Use the cord holder to hold the pedal cord.
After securing the cord with the cord holder, ensurethat
excess pressure is not applied to the connectors.
13. Connect the dedicated cord to the AC adapter. Then, plug
the AC adapter into the DC 24V connector, and wrap the
cord around the cord hook of the piano. For details, refer
to "Connecting the Power" on page 5.
14. Place the C1/C1 Air where you intend to use it. Makesure
to place it in a safe location where the floor is flatand
stable.
When setting the digital piano in place, make sure
that the stand does not rest on the AC adapter cable or
pedal cable.
For greater safety, be sure to attach the anti-tipping
brackets to the rear of the left and right side panels.

Check following assembly

□ Are any parts left over?
If any parts are left over, carefully review the assembly
procedure to see where those parts should have been used.
□ Make sure that all screws are tight.
□ Depending on the condition of the floor at the installation
location, the digital piano may shake back and forth. In
that case, attach one or two pieces of stabilizing felt to the
bottom of the anti-tipping brackets in order to reduce the
shaking (see the diagram for step 10).
Anti-tipping
Bracket
Reverse
Screws (M4)
Stabilizing felt
Cord
Pedal cord
holder