The GE front load washer is designed to allow
certain models of the GE dryer to be placed on top
(stacking). Dryer models that currently qualify for
stacking are:
•
DBVH512
•
DCVH515
•
DHDVH52
The parts and instructions necessary to convert the
separate units to a stack unit are included with the
washer installation parts.
NOTE: The stacking parts and instructions are NOT
included with the GE dryers listed above, but can be
ordered separately. (Part #: WE25X10018)
NOTE: Reverse the dryer door swing (if desired)
BEFORE stacking. The washer door swing is NOT
reversible.
•
Make sure the dryer is unplugged.
•
More than 2 people are recommended to safely
lift the dryer into position.
•
Avoid damage to the existing utility services.
•
DO NOT place the washer on top of the dryer.
•
Stacking of a gas dryer is NOT permitted in a
mobile home or a manufactured home.
Location Requirements
When installed in a location other than an alcove
or closet, the minimal clearances to combustible
surfaces and for air opening are: 0 inches on both
sides, and 1 inch at the rear.
NOTE: If the dryer is approved for installation in an
alcove or a closet, it will be stated on a label on the
back.
When installed in an alcove or closet:
•
Minimum clearance between dryer cabinet and
adjacent walls or other surfaces is 0 inches
either side, and 3 inches front and rear.
Stacking Instructions
•
cabinets, ceiling, etc. is 43 inches without
pedestal, 55 inches with pedestal, and 84
inches stacked. Closet doors must be louvered
or otherwise ventilated and must contain a
minimum of 120 square inches of open area,
equally distributed.
•
The dryer MUST be vented to the outdoors. (Refer
to dryer installation instructions for details.)
Kit Contents
Right Bracket
Left Bracket
4 Rubber Pads
4 #12 x 1" Screws
4 #8 x ½" Screws
Tools Needed
Phillips Screwdriver
Open End Wrench
Pliers
Gloves
Level
– 23 –
(Continued next page)