GE GFWS1700H Technical Service Manual page 21

3. Pull the drawer out to its stop position.
4. Remove the screws from the drawer slides.
5. Slide the drawer out of the base and set it aside.
NOTE: The support pads should be installed on the
dryer only. DO NOT INSTALL THE PADS ON THE
WASHER PEDESTAL.
6. Install a support pad at each top corner of the
pedestal. Ensure that both protrusions on each
pad are inserted in the holes on the top of the
pedestal.
7. Place the pedestal against the bottom of the
washer or dryer. Ensure that the drawer front is
at the front of the washer or dryer.
8. Align the holes in the pedestal with the holes in
the bottom of the washer or dryer base.
9. Use a Phillips head screwdriver to install the 4
(8 mm) bolts through the pedestal and into the
unit. DO NOT tighten the bolts.
10. Align the pedestal with the unit. Use an 8 mm
socket wrench to securely tighten the bolts.
– 21 –