Swapping The Heart Rate Limits; Illuminating The Display - Polar Electro S610i User Manual

In addition to the rate zone alarm you can see:
if you are exercising above heart rate zone.
if you are exercising below heart rate zone.

Swapping the Heart Rate Limits

Press and hold the up button. Repeat until the desired limits are displayed.
In the Interval Training mode the limits are automatically swapped when
the phase changes to the preset limits.
You have three optional Exercise modes depending on the selected
exercise:
• BasicUse
• Interval Training Set (Int On)
• BasicSet (Int OFF)
The following functions can be used during all three optional Exercise modes.

Illuminating the Display

Press the signal/light button.
After you use backlight once in the Measure mode, the receiver
automatically illuminates the display if you: start or stop the exercise
session, store lap information and at the end of an interval and a recovery
calculation.