Wired To A Computer (Usb); Step 3: Update Firmware; Direct Updating Over The Internet - PRESONUS StudioLive Series III Owner's Manual

2 Getting Started
2.3

Step 3: Update Firmware

Wired to a Computer (USB)

2.2.2
2.3 Step 3: Update Firmware
2.3.1

Direct Updating over the Internet

From UC Surface
Your StudioLive Series III rackmount mixer can be connected
directly to UC Surface running on a computer using USB.
Please note: In this configuration, you can only use one device – your computer – to
control your StudioLive mixer.
To begin, you have to install Universal Control and UC Surface on your computer.
Please review the StudioLive Software Library Reference Manual for complete details.
Once Universal Control has been installed, connect your
StudioLive mixer using USB and launch Universal Control.
The Control LED on the front of your StudioLive mixer will turn blue once it is
connected and communicating properly to the computer.
The easiest way to update your StudioLive Series III rackmount mixer firmware is to
connect your mixer to a device running UC Surface that also has Internet access
Power User Tip: Because direct updating from the Internet is the safest and fastest
method of updating your mixer's firmware, it is highly recommended that you use this
method whenever possible.
IMPORTANT: To use Internet updates, your PreSonus hardware must be registered to your
My PreSonus account.
Tablet control
UC Surface
Ethernet cable
1. Connect both your mixer and your UC Surface device to a
network with Internet access (wired or wireless).
2. Open UC Surface and connect to your mixer.
StudioLive™ Series III Rack Mixers
USB cable
Laptop with
Laptop with
Owner's Manual
UC Surface
UC Surface
To Internet
6