Page 1
ASSEMBLY MANUAL DIRT BIKE PIT BIKE MOTOCROSS XP125T VER. 44 2017-A-USA...
Page 2
FOREWORD In order to ship XMotos vehicles as efficiently as possible, they are partially disassembled before crating. Since some of the most commonly removed parts have a direct bearing on a vehicle’s reliability and safety, conscientious assembly and preparation becomes extremely important. This assembly manual explains step by step procedures of the following items for the XMotos XP125T.
Page 3
It California to cause Cancer, birth defects shall be acceptable to stop manufacturing a and other reproductive harm. certain model without prior notice. In the event of such modifications, please ask your local Xmotos dealer for information.
UNCRATING OPENING CRATE Clear a space about 10 ft. square to give yourself plenty of space to work. Place the crate upright on its base. Cut the straps and remove the cardboard cover. Cut away the plastic ties securing the front wheel to the crate and remove the wheel.
Page 5
UNCRATING OPENING CRATE Ø Cut away the plastic ties securing the gear shift lever and remove the lever. Ø Cut away the left and right plastic ties securing the foot rests. securing the front axle bolt. Ø Cut away the plastic ties Ø...
Page 6
ASSEMBLY HANDLEBAR Remove the two bolts from the front number plate bracket. Ø Position the handlebars on top of the handlebar clamps and push the bolts through. Ø Before tightening the clamp bolts, position the bracket under the top triple clamp as illustrated Ø...
ASSEMBLY FRONT FENDER Remove the two crate nuts and crate bolt in picture A and discard them. Cut the rear wheel steel tie to remove the motorcycle from the crate base. Support the motorcycle with a suitable stand to install the front fender, front wheel and the rear shock absorber.
ASSEMBLY REAR SHOCK ABSORBER Ø Remove the rear shock absorber nut and bolt Ø Position the shock absorber in to the mounting bracket and fasten the nut. NOTE: Rear Shock Bolt Torque - 29-31 ft. lbs.
ASSEMBLY FRONT WHEEL Ø Install the longer collar on the left side of the hub. Ø Install the shorter collar on the right side of the hub. Ø Loosely fit the axle in to the left side of the fork leg. Ø...
ASSEMBLY FRONT NUMBER PLATE Ø Position the front number plate on to the metal bracket you previously removed. Ø Make sure the bottom bracket holes on the number plate are inserted on to the plastic pins of the front fender. Ø...
WARRANTY Thank you for purchasing the XP125T Dirt Bike. Your XP125T Dirt Bike is warranted against defects in material and workmanship for the period of one year (1 Year) from the date of purchase. This warranty is limited to the original purchaser of product. Product found to be defective during that period will be repaired or replaced by 4J International Inc.