Table of Contents
Advertisement
This operation should only be done when
you insert the memory card for the first time.
During formatting various folders will be
created for different data types.
Turning the handset
on/off
Turning your handset on
Ensure that your USIM card is in your
handset and the battery is charged. Press and
hold
until the power comes on. Enter the
USIM PIN code that was supplied with your
USIM card if the PIN code request is set to
On. (Note: Please refer to page 79)
After a few seconds you will be registered on
the network.
Turning your handset off
Press and hold
until the power goes off.
There may be a few seconds delay while the
handset powers down.
Do not turn the handset on again during this
time.
Access codes
You can use the access codes described in
this section to avoid unauthorised use of your
phone. The access codes (except the PUK
and PUK2 codes) can be changed by using
the Change codes feature [Menu #.1.4.3].
PIN code (4 to 8 digits)
The PIN (Personal Identification Number)
code protects your USIM card against
unauthorised use. The PIN code is usually
supplied with the USIM card. When the PIN
code request is set to On, your phone will
request the PIN code every time it is
switched on. When the PIN code request is
set to Off, your phone connects to the
network directly without the PIN code.
PIN2 code (4 to 8 digits)
The PIN2 code, supplied with some USIM
cards, is required to access functions such as
Fixed dial number. These functions are only
available if supported by your USIM card.
23
Advertisement
Table of Contents
