Yamaha MMP1 Operation Manual page 56

5-1-3. Creating cue mixes
12.
Select formats for Cue output and Studio
Speaker output.
NOTE
Create a Cue output to perform the following.
• Set levels and mute audio on the Sub screen.
Create an Studio Speaker output to perform the following.
• Set levels and mute audio on the Sub screen.
• The Studio Speaker output will be muted while the mic is
turned on.
Settings screen - Scene - Monitor Matrix
Select "2" as the Cue 1 and Studio Speaker 1 format
under Monitor Matrix Out as both Cue output and
Studio Speaker output needs to be in stereo.
14.
Route the input source for the cue mix and the channel strip output to Cue and STU (STUdio speaker).
Monitor Matrix screen
Assuming that the cue mix audio is sent to Dante 7/8, route Dante In 7 to Cue 1-L and STU 1-L, Dante In 8 to Cue 1-R and
STU 1-R, and the output from channel strip 1/2 to Cue 1-L/R and STU 1-L/R.
5. Configuring System Settings
13.
Assign mic preamp output to a channel strip.
NOTE
While holding down the right mouse button (Windows) or
the <control> key (Mac) on the Source fields, drag up or
down on the fields to select several input sources at the
same time.
Patch screen - Input Patch
Assign Analog In 1 and 2 connected to the mic preamp
output to Channel Strip In 1-A and 2-A respectively.
MMP1 Operation Manual 56