Overview - Yamaha MMP1 Operation Manual

2. Overview

The MMP1 has three main functions.
FIR
IIR
Bass Management
Filter (32)
DAW
Mic Pre-amp
Insert
Return
1 Channel strip function
Allows for the use of up to eight channel strips, each equipped with HPF, LPF, EQ, compressor, insert send/return and
other functions. This can be used to input the signal from the microphone preamp to which the recording microphone is
connected and adjust sound quality when recording to produce a low-latency cue mix. The microphone on each
channel strip can also be turned on or off using a GPI, an iPad, or other similar device (see
functions").
2 Monitor processing function (max. 40x36 matrix)
This is used to select a Monitor Source, mix Monitor Sources, adjust levels, and control lip sync delay and cue mix
Talkback. You can also mix the output from channel strip (1) and the cue audio sent from the DAW to produce a low-
latency cue mix.
3
Speaker Management function (max. 32x32 matrix)
This adjusts monitor signals. The matrix input stage comes with a bass management crossover filter to allow for
unrestricted bass management not constrained by conventional 5.1 channel and 7.1 channel setups. This ensures
compatibility should new surround sound formats be introduced in the future.
The output stage comes equipped with 6-band EQ, delay and level adjustment trim controls, and can be used while
switching the output Speaker Set.
The following two applications can be used to operate the MMP1.
• MMP1 Editor (for Windows/for Mac)
• MMP1 Controller (for iPad)
Speaker Matrix
(32x32 Matrix Mixer)
Channel
Strip (8)
Insert Send
Outboard
(EQ, Compressor, etc.)
Trim
Delay
EQ (6)
Monitor
Alignment
Process (32)
Monitor Matrix
(40x36 Matrix Mixer)
Output Patch
2. Overview
Speaker
Out
Surround
Speakers
Monitor
Out Speaker
Processor
Cue Out
Headphone
(player)
Headphone
Out
Headphone
(engineer)
Channel Out
DAW
"5-4. Commentary
MMP1 Operation Manual 3