Listening To An External Source - Grundig TR 2500 DAB+ Manual

RADIO MODE
FM mode
For the best FM reception, it is sufficient to extend
the telescopic antenna and direct it accordingly.
Selecting the input source FM
1
Select the input source FM with
Alarm«.
– Display: »FM Mode«, then the frequency of
a FM radio station.
Selecting stored stations
1
Select the station you want using the preset
buttons »1« to »5« (presets 1 to 5) or using
e II« and the preset buttons »1« to »5«
»+5
(presets 6 to 10).
Displaying RDS station informations
RDS (Radio Data System) is an information sys-
tem which is transmitted additionally by most FM
stations.
Notes:
It may take some time before all RDS infor-
7
mation is available.
GRUNDIG has no influence on the correct-
7
ness of such information.
1
Press »Select/i« repeatedly.
– The following display appears in succesion:
The name of the radio station, radio text (if
offered), station type (PTY), the current time
and date.
24 ENGLISH
------------------------------------------------------------------------------------------------------------------------
»Mode/

Listening to an external source

1 Use a standard audio cable to connect
IN« on the back of the device to an AUDIO
OUT socket on the external equipment.
2
Press »ON/OFF« to switch on the device.
3 Select the input source for the external device
with »Mode/Alarm«.
– Display: »AUX IN Mode«.
4
Adjust the volume using
5
Start playback on the external device.
Note:
If no audio signal is available on socket
7
»AUX IN«, the device switches automati-
cally to Stand-by mode after 15 minutes. For
further use switch on the device again.
»AUX
+«.
»–