Helicopter - JETI model Duplex DC-16 Manual

computer radio control system
Note:
When setting up your spoilerons be sure that the ailerons still
have enough travel to control your airplane when the spoilerons
are deployed. In this menu the „(Sym) F1" button will link or
unlink the spoilerons if you need to set them independantly.

7.3.2 Helicopter

Let's create a simple model helicopter. In this example, the
helicopter is controlled by a swash plate with three servos at 120°
orientation and the motor has no governor.
Servo assignment for the receiver channels:
1. Throttle
2. Elevator (Swash 1F)
3. Collective (Swash 2L)
4. Aileron (Swash 3R)
5. Rudder (Yaw)
6. Gyro(Gyro sens.)
Before you begin creating a model make sure that you have set-up
the correct transmitter mode in „Main menu -> System ->
Configuration -> MODE 1-4". The basic, standardized, assignment
of transmitter inputs to flight controls are based upon this selection.
First it is necessary to first create a model in the transmitter and then
bind the DC-16 transmitter with the receiver which will control the
given model. See chapter 8.4: Receiver->Binding.
Notice: For safety reasons we strongly recommend removing the
main/tail blades or disconnecting the motor when working
with an electric helicopter.
3.
1.
display push the key „menu". Select the
item „Model" and push the „3D button".
2.
the „3D button".
3.
„F5(OK)" (Note: you must enter a model
name to proceed.) Then select the model
type „Heli". Confirm by pushing the
„F5(Next)" button.
4.
servos (def 120°)". Change the second
menu item „Position of front servo" to
„Rear" – the swash plate servo orientation
will be turned 180°. Confirm the change by
pressing the „F5(Next)" button.
27
Switch-on the transmitter. In the main
Select the item „New model" and push
Enter the name of your model and press
Select the helicopter swash plate type „3
EN
3.