Section 4 Adjustment; Section 5 Troubleshooting - JVC TH-R3 Service Manual

For the 4.6 Taking out a disc, please follow this procedure about how to taking out a disk of the product with which the DVD mech-
anism was changed.
Please refer to "TH-R3, TH-R1 (No.MB442)" about other items.
4.6 Taking out a disc
4.6.1 Method 1
There is compulsive tray ejection mode by electric operation.
(1) AC Plug is pulled out at once and inserted again.
(2) It is displayed on FL display as "PLEASE" and "WAIT" blink alternately, and while it blinks, pushing the EJECT button of a main
body is continued.
(3) After a while, a tray opens (About 20 seconds).
(4) A disk is removed, the tray is pushed, and a tray is made to close.
(5) "PLEASE" and "WAIT" blink alternately and it is displayed in FL indicator, and it will be in a standby state.
(6) If the POWER button is pushed, it will usually be operating.
4.6.2 Method 2
When the disc cannot be removed by operating above "Method 1", open the front door of the main body manually and directly press
the EJECT button located in the lower right of the drive unit.
4.6.3 Method 3
When neither "Method 1" nor "Method 2" can remove the disc, the tray can be ejected mechanically without turning the power on.
(1) Open the front door of the main body manually.
(2) Insert a fine wire (e.g. a straightened paper clip) into the hole in the lower part of the tray of the drive unit.
(3) As the tray ejects a little, pull out the tray manually.
4.7 Exchanging the fitting
As the fitting that comes with the service drive unit cannot be used, make sure to attach a service fitting when the drive unit is exchanged.
The fitting that is removed from the old drive unit can be attached to the new drive unit.
The fitting can be removed by pulling upwards while opening out the lower part of the fitting outwards.
Please refer to "TH-R3, TH-R1 (No.MB442)" about this section.
SECTION 4
ADJUSTMENT
Front door Tray Hole EJECT Button
Tray
Fitting
SECTION 5
TROUBLESHOOTING
(No.MB442B)1-5