Viking VBI7360 Installation Manual page 15

Water Line Installation
With the refrigerator in line with the cut-
out, but outside of the cabinetry, insert the
copper tubing through the indicated hole.
Push the copper tubing through the
machine compartment until it comes out
the front side of the refrigerator.
Roll the refrigerator into place in the
cabinet cut-out.
Coil the copper tubing in a vertical
loop so that the end of the copper
tube faces toward the rear of the
refrigerator.
Install nut and ferrule over end of
copper tube. Insert the end of the
copper tube into the water valve.
Tighten the nut until the ferrule fi ts
snug on the copper tube.
Turn on water supply and check for
leaks. Repair leaks if found.
Level the refrigerator, replace the
grill, and replace the toe kick.
Copper
tubing
15
Water valve