Advertisement
Installation Procedure
Step 14 Setting the indoor unit
addresses and the installation options
You cannot set both of the indoor unit addresses and
the installation options in a batch: set both of them
respectively.
Common steps for setting the addresses and
options
MR-EC00 and MR-EH00 remote controls
Entering the
mode for setting
the options
High Temp button
Low Temp button
NOTE
The remote control display and buttons may vary
depending on the model.
1 Enter the mode for setting the options:
a Remove the batteries from the remote control,
and then insert them again.
b While holding down the
(Low Temp) buttons simultaneously, insert the
batteries into the remote control.
c Make sure that you are entered to the mode for
setting the options:
20
English
2 Set the option values.
Setting the
option values
Mode button
High Fan button
Low Fan button
(High Temp) and
CAUTION
The total number of available options are 24: SEG1 to
SEG24.
Because SEG1, SEG7, SEG13, and SEG19 are the page
options used by the previous remote control models,
the modes to set values for these options are skipped
automatically.
Set a 2-digit value for each option pair in the
following order: SEG2 and SEG3
SEG6 and SEG8
SEG9 and SEG10
SEG12
SEG14 and SEG15
SEG18 and SEG20
SEG21 and SEG22
SEG24
SEG1
SEG2
SEG3
0
X
X
SEG7
SEG8
SEG9
1
X
X
SEG13
SEG14
SEG15
2
X
X
SEG19
SEG20
SEG21
3
X
X
On (SEG1 to SEG12)
SEG4 and SEG5
SEG11 and
SEG16 and SEG17
SEG23 and
SEG4
SEG5
SEG6
X
X
X
SEG10
SEG11
SEG12
X
X
X
SEG16
SEG17
SEG18
X
X
X
SEG22
SEG23
SEG24
X
X
X
Off (SEG13 to SEG24)
Advertisement
