E-Tech DrivE-Tech 015 Installing And Operating Manual page 14

Parameter
Language
XXXXXX
Unit
XXXXX
Motor type
singlephase/threephase
Rated motor Amp.
I = XX.X [A]
Rated motor freq
f = XXX [Hz]
F. scale sensor
p = XX.X [bar]
Sensor test
Press ENT
Max alarm value
p = XX.X [bar]
Motor test
START/STOP
Rotation sense
---> / <---
Set value
p = XX.X [bar]
Autorestart
ON/OFF
INITIAL SETUP
COMPLETED
14
Default
End user communication language
XXXX
Unit
bar
threephase Type of motor connected (DrivE-Tech 015,030)
Rated current of the motor per it's nameplate indication increased by
10%. The voltage drop caused by the inverter leads to higher input
XX
current than nominal. Make sure motor is capable of accepting
increased current.
Rated frequency of the motor per its nameplate.
50
Control mode: Constant value [bar]
Sensor full scale.
16
If the transducer is not connected or connected improperly, the signal
SENSOR OFF is activated when pressing ENTER.
Maximum pressure allowed in the system. If the pressure goes over
this value, an alarm occurs and the pump is stopped. Pump is
10
automatically restarted if the pressure goes below the maximum
value for a period of at least 5 seconds.
Press START/STOP to run a test at rated frequency
Warning: make sure to run the system without damaging pump and
system
If, during the test, the motor runs in reverse, it is possible to change
the wiring sequence via software without physically changing wires at
--->
the terminals.
The pressure value to be kept constant.
3
If ON is selected, after a lack of voltage, DrivE-Tech returns to its
normal status; if DrivE-Tech was powering the pump before the
OFF
voltage drop, it resumes powering the pump automatically.
Warning, review the advice in chapter 1
Once the Setting procedure is completed you will get this indication
on the display; setting parameters are recorded by DrivE-Tech; these
parameters can be set up individually in the INSTALLER Parameters
menu or ADVANCED Parameters menu.
Description