Table of Contents
Advertisement
Example, of communication setup for remote dialing or local setup
Dialing site:
Type AT in your terminal software, your modem should respond with OK.
After you received an OK, It is a good idea to clear the buffer out of your host modem before dialing.
Type, AT&F then hit Enter. To dial into the site use the standard ATDT command. If you did not receive an
OK please see Trouble Shooting Page 46.
See Example below.
ATDTXXXXXXX
After the CONNECT message displays or CD goes high. Press CTRL-W three times within one second, the
Main Configuration Menu will be displayed, after the menu displays.
You can choose an option or press option F to access to your DTE device.
Note: by hitting CTRL-W it disconnects the TXD and RXD from your DTE device and talks directly to
the CDS-9020 controller.
8
Advertisement
Table of Contents
