Table of Contents
Advertisement
Humidity: 95%, non-condensing
GETTING STARTED
Be sure product was shipped complete. If you find anything missing please contact your supplier.
STANDARD PACKAGE CONTENTS
1) CDS-9020 CDMA Modem (mounted in a powder coated box with mount ing holes)
2)
TNC Rubber Ducky Type antenna
3)
Flat ribbon cable RS-232 modem and programming cable
4)
Modem software used for setting up The Configuration Menu
5)
User Manual
6)
2 terminal blocks (2 pos for PW, 8 pos for RS-232)
Connecting to the CDS-9020
1. Plug power in, 12VDC into P3 (see figure #1)
2. On initial power up, you should see the CDS-9020 LED lights blinking on and off
3. After the light stops blinking and only the DTR LED and the PWR/Status LED are on,
the CDS-9020 is finished booting up, it takes around 20 seconds
4. Turn on computer / laptop
5. Plug in DB-9 RS-232 Cable to computer (laptop)
6. Start a terminal program (Terminal for windows 3.1, HyperTerminal, PCLUS, etc).
7. Select the correct COM Port in software usually COM 1 in most laptops. (settings)
8. Set baud rate to 19.200bps (Default for CDS9020/9021 Series) Note: if you have changed this setting,
you need to set the DTE to the same baud rate speed you set it to last time you configure the CDS-9020.
If you don't know what the DTE speed is set to, see page 45, Trouble shooting.
9. Press CTRL-W three times quickly (you need to hold down Ctrl key and press W three times in 1
second)
10. The Configuration Menu will display
(If the Configuration Menu does not display, see page 45 Trouble shooting)
Note: This can only be done after you have programmed a phone number and system I.D. number into the unit.
Dialing from the host computer with a Hayes compatib le modem.
Execute a terminal software.
Setup your software to dial the site, baud rate (19,2bps default), Com Port. Parity and Flow Control.
Now you are ready to start programming locally
Dialing into the CDS-9020 Programming Menu:
7
Advertisement
Table of Contents
