S-Registers - DATEREMOTE CDS-9020 Manual

Q1
V0
V1
X1
X2
X3
X4
Z0
&C1
&D1
&D2
T
P

S-Registers

The value of an S-register may be set by using the syntax,
Sn=xxx
where n is the register number and xxx is a decimal value.
For instance, to set the register SO to 3, the command SO=3 would be used. r1b read
register SO, the command SO? is used. The following table describes the S-registers.
S-Registers Table
Register
S0
S3
S4
S5
S6
Do not return result codes.
Display result codes as numbers.
Display result codes as words.
Enable additional result code CONNECT <rate>.
Disable dial tone and busy detection.1
Enable additional result codes CONNECT <rate> and NO
DIALTONE. Disable busy detection. Enable dial tone
detection.1
Enable additional result codes CONNECT <rate> and BUSY.
Enable busy detection. Disable dial tone detection.1
Enable additional result codes CONNECT <rate>, BUSY and
NO DIALTONE. Enable busy and dial tone detection.1
Reset to default configuration.
Circuit 109 (CF) ON in accordance with the specified service.
Enter online command state following ON-to-OFF transition of
circuit 108/2.
Enter command state following On to Off transition of circuit
108/2.
Select tone dialing.
Select pulse dialing.
Value
0
[1 to255]
13
10
8
2 to 10
2
Description
Disable automatic answering
Enable automatic answering after
Carriage Return character.
Line Feed character.
Backspace character.
Pause before blind dialing.
26