Table of Contents
Advertisement
QUALCOMM Proprietary Commands Table
Command
$QCQNC=<value>
$QCPKND=<value>
$QCCAV
$QCVAD=<value>
Basic AT Parameters
These commands control the basic configuration of the modem. The parameters can only
be read back by the &V command when in command state. The following table shows the
command format.
Basic AT Parameters Table
Parameter
E0
E1
L0
L1
L2
L3
M0
M1
M2
Q0
Description
Packet call behavior
0 - Enable IS-707 packet data.
1 - Enable Quick Net Connect packet data.
Packet Auto Detect Behavior
0 - Do not bring up packet calls unless preceded by
ATDT #7777
1- Bring up packet calls upon detection of a PPP
packet.
Instructs phone to answer current call in voice mode.
Pre-Arrangement Setting
0 - No effect
1 - Instructs phone to answer next incoming call in
Fax mode.
2 - Instructs phone to answer all subsequent calls in
Fax mode.
3 - Instructs phone to answer next incoming call in
asynchronous mode.
4 - Instructs phone to answer all subsequent calls in
in asynchronous mode.
Description
Do not echo commands in command state or online command
state.
Echo commands in command state or online command state.
Low speaker volume.
Low speaker volume.
Med speaker volume.
High speaker volume.
Speaker off.
Speaker on until carrier reported (support of this feature is
optional).
Speaker on (support of this feature is optional).
Return result codes.
25
Advertisement
Table of Contents
