Table of Contents
Advertisement
Quick Links
MODEL: UHG-842
User's Manual
FOR YOUR SAFETY, PLEASE READ THIS MANUAL CAREFULLY AND OPERATE
THE PRODUCT ACCORDING TO THESE INSTUCTIONS. KEEP THE MANUAL
FOR FUTURE REFERENCE.
For your safety - If you smell gas:
1. Shut off gas to the appliance
2. Extinguish any open flame.
3. Take off your gas cylinder valve. If odor continues, keep away from the appliance and immediately
call your gas supplier or your fire department.
Advertisement
Table of Contents
Related Manuals for UNITED UHG-842
Summary of Contents for UNITED UHG-842
- Page 1 MODEL: UHG-842 User’s Manual FOR YOUR SAFETY, PLEASE READ THIS MANUAL CAREFULLY AND OPERATE THE PRODUCT ACCORDING TO THESE INSTUCTIONS. KEEP THE MANUAL FOR FUTURE REFERENCE. For your safety - If you smell gas: 1. Shut off gas to the appliance 2.
- Page 2 Safety advice and warnings! Read these instructions carefully before switching on the appliance and keep them for future reference. Failure to follow and observe these instructions could lead to an accident. Clean all the parts of the product as indicated in the cleaning section, before use. Use or working environment: 1.
- Page 3 NOTE: The heater incoporates several safety devices that will shut down the heater in unsafe conditions. ODS (Oxygen depletion system). In case of accidental flame failure, the gas heater will shut down automatically. The Tip Over Switch will turn off the heater if it is not standing upright on a level surface. If this activates, set the heater upright, check for obvious damage and wait 10-15 minutes before attempting to re-ignite the heater.
- Page 5 Installing the heater 1. After the heater has been removed from its packaging, remove the back panel from inside the back cavity. 2. Place the filled gas cylinder into the back of the heater with the valve outlet facing outwards. 3.
- Page 6 4. IMPORTANT TEST for leaks: This must be carried out in a well-ventilated area, free from any open flames or other sources of ignition. With the regulator connected to the cylinder, turn on the gas cylinder valve 1 and 1/2 turns anti-clockwise. Brush all hose connections, pipe connections to the gas valve, regulator connection to the cylinder and gas cylinder valve with a 50:50 solution of detergent and water.
-
Page 7: If You Smell Gas
IMPORTANT: You should purchase a suitable gas cylinder for this heater. The cylinder will require purging of air the first time it is filled, to ensure correct operation of the heater. This should be carried out by the gas filling station. Your cylinder should be checked for safe operation each time. -
Page 8: Gas Pressure Regulator
Do not place the heater near walls, curtains of furniture while in operation. The heater must be always facing towards the center of the room. The correct position is indicated in the picture below: The heater must not be moved while operating. ... -
Page 9: Troobleshooting
TROOBLESHOOTING... -
Page 10: Notice About Recycling
Herewith, Amiridis-Savvidis S.A. states that this product, complies with the requirements of below directives: Gas Appliance Directive 09/142/EC CE-marking Directive 93/68/EEC The detailed declaration of conformity can be found at www.united-electronics.gr Exclusive importer in Greece: Amiridis – Savvidis S.A. 87A, 17 Noemvriou str, P.C. 55534 Thessaloniki –...
Need help?
Do you have a question about the UHG-842 and is the answer not in the manual?
Questions and answers