H3C S3600 Series Operation Manual page 11

Hide thumbs Also See for S3600 Series:

Operation Manual – DLDP

H3C S3600 Series Ethernet Switches-Release 1510

II. Network diagram

GE2/1/3

Figure 1-3 Fiber cross-connection

III. Configuration procedure

Configure Switch A

# Configure the ports to work in mandatory full duplex mode at a rate of 1000 Mbps.

<H3CA> system-view

[H3CA] interface gigabitethernet 2/1/3

[H3CA-GigabitEthernet2/1/3] duplex full

[H3CA-GigabitEthernet2/1/3] speed 1000

[H3CA-GigabitEthernet2/1/3] quit

[H3CA] interface gigabitethernet 2/1/4

[H3CA-GigabitEthernet2/1/4] duplex full

[H3CA-GigabitEthernet2/1/4] speed 1000

[H3CA-GigabitEthernet2/1/4] quit

# Enable DLDP globally

[H3CA] dldp enable

# Set the interval between sending DLDP packets to 15 seconds.

[H3CA] dldp interval 15

# Configure DLDP to work in enhanced mode

[H3CA] dldp work-mode enhance

# Set the DLDP handling mode for unidirectional links to auto.

[H3CA] dldp unidirectional-shutdown auto

# Display the DLDP state

[H3CA] display dldp 1

SwitchA

GE2/1/4

SwitchB

1-10

Chapter 1 DLDP Configuration

Table of Contents