Advertisement
Your B500 thermostat can support up to 3 Re-
mote Sensors that can measure the temperature
from 3 locations - two indoor and 1 outdoor.
You can mount the Remote Sensors on a wall
or other horizontal surface, or you can set the
Remote Sensors on tables or other horizontal
surfaces.
Consult the Thermostat Instruction Manual,
page 13, Option 8 for instructions in setting the
thermostat to accommodate the remote sen-
sors.
NOTE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for
help.
2
Advertisement
