Table of Contents
Advertisement
2 - USE OF INDUCTION HOB
Notes:
•
Each selection (by pressing one of the keys) is
indicated by an acoustic signal (beep) .
•
User interface initial calibration: this feature is for
the keyboard calibration, to adapt the sensibility of
the keys to the final mechanical, environmental and
user conditions . Any time the cooktop is connected
to the electrical supply or after a power failure (that
generates a reset in the user interface), the first
time the Key-Lock
the keyboard is readjusted .
The first touch of the Key-Lock
in certain condition: do not use gloves, use a clear
finger.
It is also important to consider that the calibration
process requires a low level of ambient light in
the area of the touch keys . If the environmental
light conditions are excessive (e .g . halogen
hood light/s on), the user interface calibration is
suspended (the cooking zones displays show
F
L
"
" and "
" alternating - error message "
the correct light conditions will be recovered .
In this case the direct environmental light/s must be
switched off before calibrating the cooktop; then,
after completing the process, the light/s can be
switched on again .
•
The touch control is switched off automatically (and
a warning beep sounds every 10 seconds):
–
if one or more keys are touched for more than
10 seconds;
–
if an object is positioned on the touch control
area;
–
in the case of spillage of liquids on the control
keys .
•
When the touch control reaches an ambient
temperature above a preset temperature the
heating elements are automatically switched off
(the displays show "
F
message "
") . In this case let the cooktop cool
down before using again .
IMPORTANT: ANY AUDIBLE NOISE WHEN IN USE
(E.G. A CLICKING SOUND) IS DUE TO THE NORMAL
OPERATION OF THE ELECTRONIC CONTROL
SYSTEM AND IS NOT THEREFORE INDICATIVE OF
AN APPLIANCE MALFUNCTION.
is touched the sensibility of
must be done
F
" and " " alternating - error
FL
") until
9
Hide quick links:
Advertisement
Table of Contents
