Return The Extender To Its Factory Default Settings; Use The Reset Button; Log In And Reset The Extender To Factory Settings - NETGEAR EX3110 User Manual

Return the Extender To Its Factory Default Settings

Under some circumstances (for example, if you lose track of the changes that you made to the extender
settings), you might want to erase the configuration and reset the extender to factory default settings.
To reset the extender to factory default settings, you can either use the Factory Reset button on the side
panel or log in to the extender and reset it.

Use the Reset Button

CAUTION:
This process erases any settings that you configured in the extender.
To use the Reset button to return the extender to its factory default settings:
1. Insert a straightened paper clip into the hole of the Reset button and hold it for about seven seconds.
2. Release the button.
CAUTION:
The extender resets and restarts. This process takes about one minute.

Log In and Reset the Extender to Factory Settings

CAUTION:
This process erases any settings that you configured in the extender.
To log in to the extender and reset the extender's factory settings:
1. Launch a web browser from a computer or mobile device that is connected to your extender network.
2. Log in to your extender:
• If your extender and router use different WiFi network names (SSIDs), enter www.mywifiext.net.
• If your extender and router use the same WiFi network name (SSID), enter http://<extender's IP
address> (for example, http://192.168.1.3).
For more information about how to find your extender's IP address, see
on page 40.
A login page displays.
AC750 WiFi Range Extender
Do not try to go online, turn off the extender, shut down the computer, or
do anything else to the extender until it finishes restarting!
Maintain and Monitor the Extender
33
Find Extender's IP Address