Whirlpool ACO450 Instructions For Use Manual page 6

Table of Contents

Advertisement

STOP FROST DEVICE CLEANING PROCEDURE
• Open the lid of the product.
• Grip the ICE BOX (M) with two hands and turn it anticlockwise (fig. S1), bringing the top indicator (H) from the
closed padlock to the open padlock position (fig. S2), then pull out the ICE BOX (fig. S3).
• Remove any ice present inside the cone (L) on the lid (free the middle hole of any obstructions), being careful not to
damage the surfaces.
• Dry the surfaces of the cone (L) on the lid with a soft cloth.
• Close the lid.
• Remove the ice contained in the ICE BOX (M), washing it with cold or lukewarm (not hot) water.
• Dry the inside and outside of the ICE BOX (M) with a soft cloth.
• Refit the ICE BOX (M), positioning the top indicator (H) at the open padlock then turn clockwise until aligning the top
indicator (H) with the closed padlock (reverse order to that followed for removing the ICE BOX).
• Close the lid.
IF THE ICE BOX (H) IS BLOCKED OR HARD TO REMOVE
If the ICE BOX (M) is blocked, do not persist in trying to remove it, but proceed as follows:
• Close the lid and check if the STOP FROST function is on or off.
- If the function is on (blue light on):
press the button (4) for 3 seconds to deactivate the function (blue light off), then press the button (4) again for 3
seconds; the STOP FROST function is reactivated (blue light on).
- If the function is off (blue light off):
press the button (4) for 3 seconds: the STOP FROST function is activated (blue light on).
• Wait about 25 minutes for completion of automatic defrost, then try removing the ICE BOX (M) again by following
the "STOP FROST DEVICE CLEANING PROCEDURE".

Advertisement

Table of Contents
loading

Table of Contents