Factory Default - Panasonic BB-HGW700A Operating Instructions Manual

Viewing Camera Images from the WAN (Internet) Side
This function allows you to view camera images by accessing the camera portal from the WAN side.
Note
To view camera images from the WAN (Internet) side, it is necessary to connect this product to
WAN. Regarding how to connect to the Internet refer to Getting Started and Using the Functions
(see page 19 onwards)
1.
Start the web browser.
2.
Enter "http:// IP address(WAN) or URL : port
number" into the web browser's address bar.
• (e.g. http://10.75.68.251:80
http://www.example.com:80
The factory default port number is 80. If the
port number is 80 there is no need to enter
it.)
Notes
• It is possible to check the status of the IP address (WAN) on the setup pages. (see page 74)
• When using this product with a service that is not a static IP service, the IP address
changes. It is recommended that you use the Viewnetcam.com service. (see page 44)
3.
Press [Enter].
• The camera portal is displayed.
Notes
• If a key mark is displayed, click on it and
enter that camera's user name and
password.
(If camera authentication has been set up,
the key mark will be displayed.)
• If a blue unmarked window is displayed,
click [Refresh Camera].
Sometimes a blue unmarked window is
displayed when the camera's
authentication setup cannot be verified or
the IP address and port number overlap.
Check the camera's settings.
• If an exclamation mark is displayed, click on
it and the camera's original password
window is displayed.
(It is displayed when a newly purchased
camera is connected.)
• If the camera and this product are
disconnected while sending or receiving
data, a key mark (when camera
authentication is setup) or a blue unmarked
window is displayed. In this case, after
checking that the camera's power supply
and connections are correctly inserted,
click [Refresh Camera].
[For assistance, please call: 1-800-272-7033]
Operating Instructions
17