Linksys WRVS4400N Manual page 23

sending or receiving data.
INTERNET Green. The INTERNET LED lights up the appropriate LED depending upon the
speed of the device that is attached to the Internet port. If the Router is connected
to a cable or DSL modem, typically the 10 LED will be the only LED lit up (i.e.
10Mbps). The LED Flashes during activity.
The Reset button can be used in one of two ways:
If the Router is having problems connecting to the Internet, press the Reset button
for just a second with a paper clip or a pencil tip. This is similar to pressing the
Reset button on your PC to reboot it.
If you are experiencing extreme problems with the Router and have tried all other
troubleshooting measures, press and hold in the Reset button for 10 seconds. This
will restore the factory defaults and clear all of the Router's settings, such as port
Reset Button
forwarding or a new password.
Ports
INTERNET The INTERNET port connects to a cable or DSL modem.
1-4 The four ETHERNET ports connect to network devices, such as PCs, print servers,
(ETHERNET) or additional switches.
The POWER port is where you will connect the included AC power cable.
POWER
The Access Point can be placed in three different positions. It can be either stackable,
standalone, or wall-mount.
Antenna The Access Point has three non-detachable 1.8dBi omni-directional
antennas. The three antennas have a base that can rotate 90 degrees
when in the standing position. The three antennas will all be used to
support 2X3 MIMO diversity in wireless-N mode.
Figure 4-2: Back Panel