Specifications - Makita HP2040 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for impact drilling in brick, concrete
and stone as well as for drilling without impact in wood,
metal, ceramic and plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Model
Speed
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Safety class
equipment and
environmentally compatible
HP2040 / HP2041
High
20 mm
8 mm
25 mm
0 - 2,900
0 - 37,700
364 mm
2.6 kg
END201-5
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Vibration
The vibration
determined according to EN60745:
Work mode: impact drilling into concrete
its
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Work mode : drilling into metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
ENE039-1
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENF002-1
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
2
Low High
----- 20 mm
13 mm 8 mm
40 mm 25 mm
0 - 950 2,900
0 - 12,400 37,700
/II
) : 94 dB(A)
pA
) : 105 dB(A)
WA
Wear ear protection
total value (tri-axial
) : 8.5 m/s
h,ID
2
) : 3.0 m/s
h,D
2
HP2042
Low
-----
13 mm
40 mm
950
12,400
364 mm
2.6 kg
ENG102-2
ENG203-2
vector sum)
2
ENG301-1
2
ENG901-1