Rf Tests; Receiver Tests; Simulate Base Station (Registration); Rssi Test - Motorola MTM800 Basic Service Manual

TEST SETUP & TESTING for 380–430 MHz and 410–470 MHz

RF Tests

Receiver Tests

Simulate Base Station (registration)

1. Turn the terminal ON
2. Check that registration and "ITSI: ---/----/01490199" (as example only) is displayed on

RSSI Test

Note: To perform the procedure below the Test Page field must be enabled using the
CPS.
Before carrying out the following steps, record the Insertion loss (dB) of the cable loss
value - (X) dB.
1. In the IFR Manual Test Mode, press the "RF Gen Level" Soft Key and enter -90 dBm.
2. Before testing, the terminal should be configured to RSSI mode using the following
3. Press the "*" key.
4. Press the "#" key.
5. Press the "Menu" key.
6. Press the "Right Navigation" key.
Hereafter, there is no need for quick sequence of pressing the control head keys.
7. Press the "Down" navigation key to scroll to "Cells Info".
8. Press "Select" using the Lower (soft) key.
9. Press the "Right" navigation key to scroll to the RSSI monitoring screen.
10. Press "Trace" using the Lower (soft) key.
When the terminal is in Trunked Mode, continue with step 2. Otherwise perform steps
a through c.
a. Press "Options" using the Lower (soft) key
b. Press the "Down" navigation key to scroll to "Trunked Mode".
c. Press "Select" using the Lower (soft) key
the IFR "Manual Test" screen.
Note: The number "01490199" is the terminal ID (ISSI) which is displayed when the
terminal is switched on.
sequence. When performing steps 3 through 6, make sure that you press the control
head keys sequentially (less than a second between every consecutive press).
5.1 - 9