Installation Steps; Basic Operations; Making A Call; Messaging - LG LSP-410R User Manual

Introduction

2.4 Installation Steps

Please follow the procedure below to install the phone properly.
1
Connect basehandset
to the handset
connector.
3
Turn the antenna
upright.
5
Connect the AC
power supply.
Notice
▶
Before using the phone, please check that the battery switch is "on".
▶
After switching if on, use the phone.
▶
When charging the battery, check that the battery switch is "on".
▶
The battery will be charged only when the battery switch is "on".
14
2
Connect the antenna
to the TNC connector
(Turn right).
When you first use the
4
phone, please Turn
"on" the battery
switch.
6
Press END/PWR
button to operate
initially.

3.1 Making a Call

You can make a call as follows.
1. Pick up the handset or press button.
2. Listen for dial tone.
3. Enter the phone number with area code if
needed.
4. Wait for the Auto Time-out or Press Dial/Flash
button.
5. The call is connected and you may start
conversation.
6. To disconnect the call, replace the handset or
press button.
When the user presses the Dial/Flash button after
dialing any desired number, if the user picks up the
handset or presses the Speaker Phone button, the
phone makes a call immediately.

Basic Operations

3.2 Messaging

You can send or receive a short message. If you want
Message Write
to send SMS, press button + 1 in
on-hook state and write "send to" number / message
that you want and send your message. When the
message received in idle state or during a call, you can
confirm your message as follows.
1. Press Message button + 2 ( Inbox ) +
1 ( View SMS ).
2. Press Soft key 1 View to confirm desired
message.

3.3 Redialing Last Number

You can make a redial to last number, shown in All
Calls.
1. Pick up the handset or press button.
2. Listen for dial tone.
3. Press Dial/Flash button.
15