Vimtag CM1 User Manual page 38

CM1 USER MANUAL
Red
green
lights
flashing
alternately
(OFF
STATE2/STA2
( ) Red light
Flashing
services
Wi-Fi for adhoc mode
(Wi-Fi did not
configure the router /
router connection
failed / DHCP fails to
\
enter this mode), you
can Wi-Fi terminal
(mobile phone / pad /
notebook computers)
connected to the
wireless network, and
then access the
camera through
192.168.188.254.
Ethernet is disabled
by the user or the
network cable is not
connected
Ethernet
hardware failure
Network
connected,
address is obtained
IP address has been
obtained or the user
to configure a static
red IP address, is trying
to communicate with
the gateway
References Cloud Camera Quick
Installation Guide
1. Users press RESET 5 seconds to
restore the factory settings.
2. Check \ replace the camera and
or connect the network cable between
card the routers.
3.
Camera hardware failure, requiring
repair.
cable is 1. Please make sure your routers
the IP DHCP server is enabled.
2. Try to restart the router.
3. Manually assign a letter to the
Ethernet IP address of the router the
same gateway.
1. Confirm whether the router is good.
2. Camera hardware failure, requiring
repair.
36