Vimtag CM1 User Manual page 34

CM1 USER MANUAL
... Restore your camera to factory settings by press "RESET" key one time on
camera bottom
... Disconnect router power supply and connect it again to restart
Try again to make your camera work after the above checking.
2). Why is network connection unstable?
Network cable may get a problem. You can PING the address of a existing
device in the same network. If network cable connects right and network connect
right, you should get a reply like bytes = 32 time = 2 ms.
Another possibility is that the network equipments like hubs and switches may
have problems. Ensure all network equipments connect and work well.
3). Why does the APP show camera not online?
This may be caused by firewall protection (such as MAC addresses filtering,
MAC address binding with the IP address). In this situation, please contact your
system administrator to check firewall. Firewall may need some configuration
changes. For more information, please refer to camera installation.
Ensure STATE1 (
Router default settings may have a problem. Ensure router DHCP server is on.
If there are multi-level routers, each should connect the other trough WAN (for
example, the 1rs router LAN connects the 2
) or STATE2 ( ) flashes 3 times every 3 seconds.
32
router LAN by a network cable). If
nd