2.1.11 Removing the power transformer assembly
(See Fig.22, 23)
• Prior to performing the following procedure, remove the metal
cover, the rear cover, the CD-R mechanism assembly and the
rear panel.
• Remove the assembly consisting of the power amplifier board,
the power amplifier sub board and the main board fromthe
chassis incompletely (Refer to Fig.17).
(1) Remove the cord stopper upwards on the back of the body.
(2) Disconnect the power cord from connector J1000 on the
board of the power transformer assembly.
(3) Remove the four screws L attaching the power transform-
er assembly.
1-12 (No.22036)
Power transformer assembly
J1000
Power cord
Cord stopper
Fig.22
Power cord
Cord stopper
L
Power transformer assembly
Fig.23
J1000
L