Vertical Mounting; Satellite Speaker Mounting; Horizontal; Vertical - Monoprice 16220 User Manual

Vertical Mounting

1. Use the included wall template to mark the screw locations on your vertical surface.
Ensure that it is not located in a position where it could fall on people or animals in
the event that it becomes dislodged. Additionally, it should be positioned so there
is no obstruction close to the port on the front.
2. Obtain two screws with a head diameter from 5-7mm (not included). The use of wall
anchors is highly recommended. If necessary drill pilot holes using an appropriately
sized drill bit. Screw the two screws into the wall, leaving about 1mm space
between the wall and the screw head.
3. Using the four included screws, attach the keyhole brackets to the side of the
subwoofer. Note that the narrow end of the keyhole should be on top.
4. Peel the protective backing from two of the included rubber feet and attach them
to the side of the subwoofer, beneath the two keyhole brackets.
5. Position the large holes on the keyhole brackets over the screw heads in the wall,
then slide the subwoofer down a few millimeters so that the screw shaft and head
lock into the narrow part on the keyhole. Pull gently on the subwoofer to ensure
that the attachment is secure.

SATELLITE SPEAKER MOUNTING

The satellite speakers can be placed on a shelf or other horizontal surface or attached to a
vertical surface using the included wall mounting brackets.

Horizontal

No preparation is required for horizontal mounting.

Vertical

1. Determine where each wall bracket will be mounted to your vertical surface. Place
the bracket against the wall and mark the holes using a pencil.
11