Advertisement
If you are running the cable through the side of the Mounting Base:
(Option b)
Step 1b: Attach the SRA-25 antenna to the Mounting Base using the washer
and nut as shown in the diagram at right). Use the assembly as a template to
mark locations for the mounting screws
Step 2b: Position the gasket so that the cable exit notch is available to make a
neat seal, as illustrated on page 4, and route the cable through the base.
Step 4b: Position the cable in the gasket's slot while fitting the gasket into
position in the Mounting Base.
Step 5b: Attach the assembly to the surface, orienting it so that the cable notch
faces away from oncoming wind. Do not overtighten.
The supplied mounting screws will accommodate most surfaces. If you find
them too long, too short, or otherwise unsuitable for your application, substitute
wood screws, machine screws/washers/nuts, or other hardware (not supplied).
Be sure to use only stainless steel hardware, and be sure to use the four supplied
grommets with the hardware you choose. If you find it too difficult to start the
screws, drill 7/64" pilot holes.
Skip to "Completing the installation" below.
Step 1: Route the cable to your satellite radio receiver.
IMPORTANT: If your satellite receiver is an older model that has two
antenna input terminals, the optional SRS-1 Splitter may be required. Newer
models may differ, so consult your dealer or Shakespeare for up-to-date
information.
Step 2: Attach the SMB connector to your satellite radio receiver. See the
receiver's manual for precautions and instructions. Done!
Completing the installation
Advertisement
