Advertisement
FIGURE 1
Direct surface mounting for surfaces up to 1/4" thick
SRA-25 antenna
Lock washer
Retaining nut
Step 3: Secure the antenna to the mounting surface with the supplied retaining nut
and lock washer (see Figures 2 & 3). A small bead of RTV around the outer edge of
the antenna base is recommended to insure a watertight seal.
Skip to "Completing the installation" on page 5.
SURFACE MOUNTING USING STYLE SM-32 MOUNTING KIT
NOTE: The Style SM-32 Surface Mounting Kit makes it possible to
mount the SRA-25 to a surface that has restricted or non-existent access
underneath. The SRA-25 is sold both with and without the SM-32 Kit
included. If your antenna does not have the SM-32, you must purchase it
separately, if needed.
If you are attaching the antenna/SM-32 assembly to a flat surface, the cable
with its connector attached can be routed through a 9/16" hole drilled in the
mounting surface, or passed through the Mounting Base. Do not cut the cable and
do not remove the connector.
If you are running the cable through the mounting surface
Step 1a: Drill a 9/16" center hole for the antenna cable. When drilling fiberglass
surfaces, use a small backup block of scrap wood to control push-through
splintering. Use caution to avoid drilling through or near fuel lines, fuel tanks,
hydraulic lines, or electrical wiring.
Step 2a: Attach the SRA-25 antenna to the Mounting Base using the washer and
nut as shown in the diagram at right). Use the assembly as a template to mark
locations for the mounting screws
Step 3a: Orient the gasket so as to block the cable exit notch, as illustrated on
page 4.
6" SRA-25 cable
Mounting surface
Cable to receiver
FIGURE 2
Direct surface mounting for surfaces 1/4" – 1" thick
SRA-25 antenna
Extension
Shaft
Lock washer
Retaining nut
6" SRA-25
cable
Mounting surface
Cable to receiver
:
(Option a)
Advertisement
