Advertisement
Step 4a: Pass the cable through the hole and attach the assembly. The supplied
mounting screws will accommodate most surfaces. If you find them too long,
too short, or otherwise unsuitable for your application, substitute wood screws,
machine screws/washers/nuts, or other hardware (not supplied). Be sure to use
only stainless steel hardware. If you find it too difficult to start the screws, drill
7/64" pilot holes.
Skip to "Completing the installation" on page 5.
Mounting screw
Mounting Base
Mounting
Gasket
Rotate the gasket 180° to expose or cover the cable slot.
Cable Exit Notch Orientation
SRA-25 antenna
6" cable and connector
Grommet
Lock washer
Hex nut
Advertisement
