Contents Guide to the Appliance Caring for the Environment Safety Information and Warnings Getting Started Basic Set Up Reversing the Door Swing Troubleshooting Care and Maintenance...
Guide to the Appliance NOTE: Due to production improvements, the unit you purchased may vary slightly from the below sketch. 1. LAMP SWITCH 2. CABINET 3. LEVELLING LEGS 4. GLASS DOOR 5. SHELVES 6. INTERIOR LAMP 7. THERMOSTAT KNOB...
Caring for the Environment Responsible disposal of the packaging The packaging of your appliance has been selected from environmentally friendly materials and can usually be recycled. Please ensure these are disposed of correctly. Plastic wrapping can be a suffocation hazard for babies and young children, please ensure all packaging materials are out of reach and are safely disposed of.
Safety Information and Warnings Read this manual thoroughly before first use, even if you are familiar with this type of product. We have provided many important safety statements in this manual concerning the use of this appliance. Always read and observe all safety statements. They reduce the risk of fire, electric shock and injury when correctly adhered to.
Safety Information and Warnings Installation Heavy: This appliance is heavy, take care when moving it. To avoid back or other injury, consider a two person lift or mechanical aid when installing it. Location: The room for installing appliance must be at least 1M³per 8g of refrigerant. The amount and type of refrigerant in the appliance can be found on the rating plate on the back of...
Safety Information and Warnings Usage conditions and restrictions Indoor domestic use only: This appliance is intended for indoor household use only. It is not suitable for commercial, industrial or outdoor use. Intended purpose: Do not use this appliance for anything other than its intended purpose and only use it as described in this manual.
Getting Started Before first use • Unpack the appliance but keep all packaging materials until you have made sure your new refrigerator is undamaged and in good working order. • Plastic wrapping can be a suffocation hazard for babies and young children, so ensure all packaging materials are out of their reach.
Page 9
Getting Started • Locate the beverage fridge • Away from direct sunlight, which may affect the acrylic coating. • Away from sources of heat (stove, heater, radiator, dishwasher, etc.), which may increase power consumption. • In an area without extreme cold ambient temperatures, which may affect cooling performance.
Basic Set Up Operating your beverage centre It is recommended you install the beverage center in a place where the ambient temperature is between 22 -25 degree Celsius. If the ambient temperature is above of below the recommended temperature, conditions may cause interior temperature to fluctuate.
Reversing the Door Swing This beverage fridge can be opened from either the left side (as supplied) or right side to suit your individual installation requirements. If you want to open the door from the right side, follow the instructions below and opposite to reverse the door swing (the numbers in brackets refer to the parts in the illustrations).
Troubleshooting If you experience a problem with your beverage fridge, check in the following table for solutions to help you solve the problem. If after these checks you still have a problem with your beverage fridge, call the after sales support line for advice. Problem Possible cause The beverage fridge does not...
Page 13
Troubleshooting The external beverage fridge • The exterior walls can be warmer than room surface is warm. temperature. This is normal while the compressor works to transfer heat from inside the beverage center cabinet. • The beverage fridge door has been left open. Excessive frost and ice has built up.
Care and Maintenance Changing the light bulb NOTE: All parts removed must be saved to do the replacement of the light bulb. Before removing the light bulb, either unplug the refrigerator or disconnect the electricity leading into the refrigerator, failure to do so could result in electrical shock or personal injury. Defrosting the beverage centre When? For the most efficient operation and minimum energy consumption, defrost the appliance when the frost accumulated on the evaporator is about 5mm thick.
Care and Maintenance During long absences, remove all the bottles; unplug your beverage fridge, clean your beverage center, and leave the door open slightly to avoid possible formation of condensation, mold or odours Energy saving tips Place the beverage fridge in the coolest area of the room, away from heat-producing •...
Need help?
Do you have a question about the GVASM1-15 and is the answer not in the manual?
Questions and answers