GVA GVABF115 Instruction Manual

GVA GVABF115 Instruction Manual

115l bar fridge

Advertisement

115L Bar Fridge
GVABF115
/
Instruction Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GVABF115 and is the answer not in the manual?

Questions and answers

Summary of Contents for GVA GVABF115

  • Page 1 115L Bar Fridge GVABF115 Instruction Manual...
  • Page 2: Important Safety Instructions

    Important Safety Instructions WARNING – Always operate the product from a power source of the same voltage, frequency and rating as indicated on the product identification plate. WARNING – The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Page 3 - Do not place vases, filled with water, on the appliance. - Do not block any ventilation openings, Ensure that vents are not covered by newspapers, tablecloths, curtains etc. Do not install in a tight-fitting cabinet. - After installation, the appliance should be left for 2 hours before it is switched on in order to allow the refrigerant to settle.
  • Page 4 Parts Due to the production’s improvement, the unit you purchased vary slightly from below sketch. 1. Cabinet 7. Levelling feet 2. Drip tray 8. Bottle racks 3. Shelf 9. Recessed handle 4. Glass cover 10. Door switch 5. Compressor (back) 11.
  • Page 5 Installing NOTE: Before using the refrigerator, remove all the exterior and interior packaging. To ensure correct operation, this appliance must not be located where the temperature will be below 10°C or rise above 43°C. Good Ventilation For the purpose of easy dissipation of heat, high efficiency of refrigeration and low power consumption, a space or clearance is required around the refrigerator.
  • Page 6: Using The Appliance

    Using the appliance Before Use - When using the refrigerator for the first time, remove all securing tapes. - Wash the interior of the cabinet with warm soapy water and dry thoroughly. - Plug the unit into a power outlet and switch on. Ensure power outlet is rated to conform to the details on the rating label.
  • Page 7: Reversing The Door Swing

    Reversing the Door Swing The side at which the door opens can be changed from the left hand side (as supplied) to the right side, if the installation site requires. Should you require reversing the opening direction of the door, please follow these instructions. Warning: When changing the side at which the door opens, the appliance must not be connected to the mains.
  • Page 8: Care And Maintenance

    Care and Maintenance To keep your domestic refrigerator operating efficiently and safely, periodic inspection and cleaning of several components once a month is recommended. Cleaning your refrigerator - For safety reason, switch off and unplug the appliance from outlet before cleaning. Remove by grasping the plug - do not pull on the cord.
  • Page 9 Defrosting the Refrigerator To defrost the refrigerator, simply turn the thermostat to the “0” position and remove the power plug from the power outlet. Place the drip tray under the evaporator to collect the water. Remove the food and leave the door open. When the ice has melted, wipe the interior with a soft cloth, reset the thermostat to 5, turn the unit on and replace the food.
  • Page 10: Changing The Light Bulb

    Changing the lightbulb CHANGING LIGHTING BULB 1. Remove the water drip tray. 2. Hold the lamp cover and push towards inside of the cabinet. 3. Remove the lamp cover. 4. Unscrew the bulb and screw in a new 10W bulb. 5.
  • Page 11: Troubleshooting

    Troubleshooting Before calling for service , please check the following issues first: The Appliance - The Appliance is not - Switch ON the appliance. does not operate switched ON. - Insert mains plug. - Mains plug is not plugged - Check fuse, replace if in or is loose.
  • Page 12 The compressor does not - This is normal, no error has - The compressor starts after start immediately after occurred a period of time. changing the temperature setting. Water on the floor or on the - This is normal because of - Wipe the floor with a dry storage shelves condensation...

Table of Contents