Replacing Oven Light - Whirlpool GH7208XR Use & Care Manual

The microwave oven light is a 10W low-voltage halogen capsule
bulb. It will automatically come on when the door is opened and
when the oven is operating. See "Assistance or Service" section
to reorder. You will need a TORX T10
bulb cover.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Lift the screen off the exhaust vent at the top of the oven.
If using recirculating exhaust venting, skip Step 3.
A
A. Vent screen
B. Bulb cover (under screen)
3. For wall or roof venting, remove the metal bracket by
removing the mounting screws (1 from each end), and lifting
out the bracket.
A
A. Bulb cover
B. Metal bracket
C. Metal bracket mounting screw
†®TORX is a registered trademark of Textron Innovations Inc.
32

Replacing Oven Light

®†
screwdriver to remove the
B
B C
4. Remove the bulb cover mounting screw, then lift cover..
A. Bulb cover mounting screw
5. Remove the burned-out bulb by squeezing the wire clip
together, pulling to the right and lifting.
6. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. Do not touch bulb with bare fingers.
7. Close bulb cover, and fasten with screw.
If using recirculating exhaust venting, skip Step 8.
8. For wall or roof venting, replace the metal bracket removed in
Step 3.
9. Plug in microwave oven or reconnect power.
A