Replacing Cooktop Light; Replacing Microwave Oven Light - Whirlpool Roper MHE16XSD0 Use & Care Manual

Table of Contents

Advertisement

To Remove and Replace Charcoal Filter:
1. Remove the 2 vent grille mounting screws located directly
behind the top louver.
A
B
A. Vent grille
B. Top louver
C. Mounting screws
2. Tip the vent grille forward and down, then lift to remove.
3. Slide filter back slightly, lift front end, and pull out filter.
4. Install new charcoal filter.
5. Replace vent grille and mounting screws.

Replacing Cooktop Light

The cooktop light is a candelabra base bulb. See "Assistance or
Service" section to reorder.
To Replace:
1. Unplug microwave oven or disconnect power.
2. Remove the bulb cover mounting screw.
A
A. Mounting screw
3. Replace light. Close bulb cover. Replace mounting screw.
4. Plug in microwave oven or reconnect power.

Replacing Microwave Oven Light

The microwave oven light is a candelabra base bulb. It will
automatically come on when the door is opened and when the
microwave oven is operating. See "Assistance or Service"
section to reorder.
C
To Replace:
1. Unplug microwave oven or disconnect power.
2. Remove the 2 vent grille mounting screws located directly
behind the top louver.
3. Tip the vent grille forward and down, then lift out to remove.
4. Lift up the bulb cover.
5. Replace light. Close bulb cover.
6. Reattach vent grille. Replace the mounting screws.
7. Plug in microwave oven or reconnect power.
A
B
A. Vent grille
B. Top louver
C. Mounting screws
A
A. Bulb cover
C
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Roper mhe16xsRoper mhe16xsq0Roper mhe16xsb0

Table of Contents