Joerns Healthcare UltraCare XT User & Service Manual page 7

Installation of Mattress Side Stop (Figure 6)
The mattress side stop is designed to help keep
mattress from sliding laterally on the mattress
support platform. Mattress side stop can be installed
in combination with assist devices/rails or as a
stand-alone accessory. Please read important
warnings related to mattress side stops and follow all
instructions below, prior to use.
Installation Steps
Tools Required: #2 Phillips Screwdriver
1. Insert the ends of the mattress stop up through the
bottom of the bushings in the foot section of the
mattress support platform.
2. Pulling up in the center of the mattress stop may
help.
3. Install the screws from the top into the mattress
stop.
4. Replace mattress, making sure mattress fills width
between stops. Also, make sure mattress will not
compress to less than 1.5" depth under user's
load, especially when user is sitting on or sliding
over mattress side stop.
IV Sockets
Joerns UCXT bed has four IV sockets as standard
®
equipment. There are two sockets at head end of
bed and two at foot end (Figure 7). The IV sockets
are compatable with Joerns IV poles and most ½"
IV poles.
Installation Of Staff Control Panel
(Optional) (Figure 8)
1. Mount foot panel on bed as indicated in
previous instructions.
2. Unscrew cap located under bed frame at foot
end, (Figure 9) and secure cable connector, arrow
facing up into plug (Figure 10).
3. Ensure that the cable connector is fully inserted
into the plug (Figure 11).
4. Screw on cap from cable to secure cable
(Figure 12).
Figure 9
Arrow up
Figure 10
Figure 6
Figure 7
Figure 8
Figure 11
© 2015 Joerns Healthcare • 6110045 RevI • 15-2010
Joerns® Bed Frames
UltraCare®XT
IV Socket
Figure 12
7