Specifications - Sony CMT-DX400 Operating Instructions Manual

Notes on discs
• Before playing, clean the disc with a cleaning cloth.
Wipe the disc from the center out.
• Do not use solvents such as benzine, thinner,
commercially available cleaners or anti-static spray
intended for vinyl LPs.
• Do not expose the disc to direct sunlight or heat
sources such as hot air ducts, nor leave it in a car
parked in direct sunlight.
• Do not use discs encircled with a protection ring.
This may cause a malfunction to the system.
• When using discs that have glue or similar tacky
substance on the label side of the disc or that used a
special ink when the label was printed, there is a
chance that the disc or label may become attached to
parts inside this unit. When this occurs, it may not be
possible to remove the disc, and may also cause this
unit to malfunction. Be sure to check that the label
side of the disc is not sticky before using.
The following types of disc should not be used:
– Rental or used discs with attached seals where the
glue extends beyond the seal. The perimeter of the
seal on the disc is tacky.
– Discs that have labels printed using a special ink
that feels tacky when touched.
Cleaning the cabinet
Clean the cabinet, panel and controls with a soft cloth
slightly moistened with mild detergent solution. Do not
use any type of abrasive pad, scouring powder or
solvent such as thinner, benzine or alcohol.

Specifications

CMT-DX400
Amplifier section
Power output (rated):
Continuous RMS power output (reference):
The following measured at 220 V – 240 V AC,
Power output (rated):
Continuous RMS power output (reference):
* The system is not support C-Load testing.
Inputs
Audio In (3.5mm stereo jack):
MIC (monaural mini jack): sensitivity 4 mV,
Outputs
VIDEO OUT (phono jack):
COMPONENT VIDEO OUT:
PHONES (stereo mini jack):
SPEAKER:
20 + 20 watts (6 ohm at
1 kHz, 1% THD)
25 + 25 watts (6 ohm at
1 kHz, 10% THD)
50/60 Hz
20 + 20 watts (6 ohm at
1 kHz, 1% THD)
25 + 25 watts (6 ohm at
1 kHz, 10% THD)
sensitivity 700 mv,
impedance 10 kilohms
impedance 10 kilohms
max. output level
1 Vp-p, unbalanced,
Sync negative,
load impedance 75 ohm
Y: 1 Vp-p, 75 ohm
P , P : 0.7 Vp-p, 75 ohm
B R
accepts headphones of
32 ohm
accepts impedance of
6 ohm
continued
GB
31