Advertisement
"SensorSecure"
indicator light
(15) flashes.
The
clotbes
ten,at'),
stick.
Water drips out
of the soleplate
(7) together
with steam.
1. The "SensorSecure" system
has been activated. The iron
is set to stand-by.
"i.The
temperature
Is
to~:.high.
1. Temperature control (12)
setting is too low.
2. Steam regulator (3) is set
too high in conjunction with
a low temperature.
3. You have pressed the shot
of steam button
~
(2)
repeatedly without waiting
for 5 seconds between each
press.
1. Grip the handle of the iron to
re-start it.
';~;1 ~. Turn
'the tempe-rature co"!trqi .{~ 2)
,down
and wqit
until the
iron.nas
:fx>t?led dOVlf1.,{
1. Turn the temperature control to a
higher setting (between
U • • "
and
"max") and wait until the pilot light
(13) goes out.
2. Set the steam regulator (3) to a
lower setting.
3. Wait 5 seconds between each
press of the shot of steam button.
1. This may be caused by the
1. This is normal and will stop after a
lubrication of some of the
few minutes.
internal parts.
If none of the above solves the problem, get in touch with an authorised technical service.
* Model dependent
Advertisement
