Troubleshooting - Cuisinart DGB-800 Series Instruction Booklet

TROUBLESHOOTING

PROBLEM CAUSE
The coffeemaker Filter door is not closed
is beeping.
Filter basket is not in
place
Coffee grounds and filter
from previous use are
still in filter basket
The brew cycle There is no water in the
will not start water reservoir
Coffee is weaker There are not enough
than usual beans in the hopper
Strength setting
is incorrect
The coffeemaker The hopper may be
is not grinding too full
beans
EMPTY Coffee grounds and filter
appears in LCD from previous use are
display still in filter basket
CLEAN is flashing Coffeemaker needs to
on the LCD when be decalcified
the unit is turned
on
The coffeemaker The water reservoir is
will not enter empty
CLEAN mode
SOLUTION
• Check to be sure that all components of the filter compartment are in place
• Close filter door (you will hear a click if the door is properly shut)
• Open filter door by pressing the filter door release button
• Hook filter basket with cover onto door
• Close filter door (you will hear a click if the door is properly shut)
• Remove filter and used coffee grounds
• Add new filter
• Fill the water reservoir using the water level markings
• Be sure there are enough beans in your hopper for the amount of coffee you
intend to brew
• Check your strength setting — displayed on the LCD screen
• To change your strength setting, press the Strength Control button
• Turn the coffeemaker off and unplug
• Remove some of the beans from the hopper
• Remove filter and used coffee grounds
• Add new filter
• Run a clean cycle – follow the decalcification directions on page 11 of
Instruction Booklet
• Fill the water reservoir with decalcification mixture before turning the
coffeemaker on - Follow the decalcification directions on page 11 of
Instruction Booklet
13