Troubleshooting - Cuisinart SS-6C Instruction Booklet

TROUBLESHOOTING

PROBLEM:
Brewer does not have
power .
Brewer will not brew .
Chlorine or mineral
taste in coffee .
Brewer doesn't brew a
full cup .
Coffee is too weak or
watery .
All lights are flashing in
sequence when turning
on unit .
SOLUTION
Plug brewer into an independent outlet .
Make sure the brewer is securely plugged in .
Plug into a different outlet .
Reset your home's circuit breaker .
Confirm the power has been turned on and the On/Off and
brew buttons are illuminated .
Turn off and unplug the brewer for 30 seconds or more .
When you plug the brewer back in, be sure to turn the
power back on .
If the Add Water indicator is illuminated, check to make
sure the water reservoir is properly filled . If not, add at least
11 oz . (325 ml) of water . If the Add Water indicator is
illuminated even after adding at least 11 oz . (325 ml) of
water to the water reservoir, contact Consumer Service at
1-800-472-7606 .
The exit needle may be clogged (see page 12) .
Make sure brew head is fully closed .
Consider using bottled water, filtered water or replacing the
Cuisinart Charcoal Water Filter .
Turn off and unplug the brewer for 30 seconds or more .
When you plug the brewer back in, be sure to turn the
power back on .
The exit needle may be clogged (see page 12) .
Clean the brewing chamber
(refer to Cleaning and Maintenance, page 12) .
De-scale the brewer (refer to page 13) . If you have repeated
the de-scaling procedure two times and it is still brewing
only a partial cup, contact Consumer Service at
1-800-472-7606 .
Consider brewing a smaller cup size or try an Extra Bold
capsule . It has 30% more ground coffee in each portion
pack .
De-scale the brewer (refer to page 13) . If you have repeated
the de-scaling procedure two times and it is still brewing
only a partial cup, contact Consumer Service at
1-800-472-7606 .
14